With the die-cast aluminum Visual Volume, the rocker position is indicated by a column of ten LEDs. With the rocker fully back (toe up, heel down) all of the lights are off and so is the volume. As you rock your foot forward, the indicators light up one by one until all 10 are lit. When all lights are on, you're at maximum volume. To find your level at a glance, LEDs 1-4 are blue, 5 is red, 6-9 are blue again, and 10 is red.
The Visual Volume Pedal operates on 9V battery or an optional power supply. It will function passively without power though the LEDs will be inoperative.
Visual Volume recommends using a high-quality regulated 9VDC adapter like the 1 Spot. Boss PSA, Dunlop ECB-03, Ibanez AC-109, and Morley 9V also acceptable. The Visual Volume pedal is easy to service. If you ever wear out the control pot, Visual Volume has a kit to restore your pedal to like new service. Many users are even able to make the switch themselves.
Inputs and Outputs Input 1 and Output 1 are all you need for mono volume control. Tuner Out: Even with the volume all the way down, the tuner out still sends volume to your tuner, allowing you to tune silently without switching any cables around. If you don't plug into Input 2, both Outputs send the signal from Input 1, so you can plug into 2 different amps at the same time. Plug into inputs 1 & 2, and the Visual Volume becomes a stereo volume pedal. Great if you put a Stereo Chorus pedal in front of the Visual Volume. Or, plug 2 guitars into the Visual Volume and you can make quick guitar changes without unplugging. Other adjustments With the removal of the bottom plate on your pedal you can set the pedal for active or passive mode, adjust pedal tension, and in active mode, individually set the gain for each input. FEATURES Die-cast aluminum housing Blue and red LEDs Active and Passive modes Clean boost pre-amp in active mode Two inputs and outputs for mono or stereo use